Vulk Hydroc Plug 15Kg Pail

Vulk Hydroc Plug 15Kg Pail

Regular price
$143.40
Sale price
$143.40
Regular price
Sold out
Unit price
per 

Price excludes GST

Talk To Sales

(03) 9770 8491

Mon-Fri: 8AM - 5PM

Gabriel Lucas
Vulk Product Specialist
Gabriel has over 15+ years experience in concreting, screeding and finishing, concrete reinforcement.

Found a lower price somewhere else? We'll match it!*
Request a price match. *T&C's apply!

Pay nothing for up to 60 days with Shift!
Get an additional 30 days FREE on top of our 30 days standard payment terms from interest and repayments.

 

 

Product Description

Hydroc Plug is a fast setting, single component cementitious plugging mortar

Hydroc Plug is a fast setting, single component cementitious plugging mortar that permanently stops seepage of water and pressure leaks from cracks and construction joints.

Benefits:
- Permanently stops seepage of water and pressure leaks from cracks and construction joints
- Chloride free, ready for use grey powder based on Portland cement with special additives that is suitable for use in various structures composed of concrete, rock, timber and masonry
- High freeze/thaw, carbonation and sulphate resistance
- Use for repair of vertical, horizontal and overhead applications stopping water from static cracks and holes in situations 

Application Instructions:

Surface Preparation
Hydroc Plug must be applied to a clean surface free of contaminants. Remove any weak, spalling, unconsolidated concrete and existing coatings prior to thoroughly cleaning the surface. The use of mechanical preparation such as pressure or grit blasting may be required to ensure a clean and suitable substrate.

Application Method
Thoroughly and quickly mix the powder and water for no more than 60 seconds in approx. mass ratio of 3 to 1. (Hydroc Plug to water).
Some heat will be released. Mix only the quantity that can be immediately applied by gloved hand or trowel.
Quickly place the mixed mortar firmly into the leaking voids and hold in place with a gloved hand or trowel until the mortar is sufficiently hard to remain in place.
When the leak is completely stopped, a 2-3 mm layer of Hydroc Render can be applied over the Hydroc Plug mortar.
If the water pressure is very high and dislodges the applied mortar, use a timber plug or similar which can then be covered and secured with Hydroc Plug mortar.
Plug shall be applied from the lowest point of water leak or seepage working up to the highest progressively.
It is recommended that situations of high-water pressure be released by drilling a penetration in the substrate and installing a drainage pipe prior to applying Hydroc Plug to areas of existing leakage. When complete, remove pipe and apply Hydroc Plug to the penetration.

Curing Time
All exposed areas should be thoroughly cured. This should be done as soon as the surface is firm, by the use of concrete curing membrane, continuous application of water or wet hessian.

Request A Free Quote

Please fill out the below form for a nonobligatory written quote on a Vulk Hydroc Plug 15Kg Pail.