Vulk Hydroc Fairing Coat 20Kg Bag

Vulk Hydroc Fairing Coat 20Kg Bag

Regular price
$211.80
Sale price
$211.80
Regular price
Sold out
Unit price
per 

Price excludes GST

Talk To Sales

(03) 9770 8491

Mon-Fri: 8AM - 5PM

Gabriel Lucas
Vulk Product Specialist
Gabriel has over 15+ years experience in concreting, screeding and finishing, concrete reinforcement.

Found a lower price somewhere else? We'll match it!*
Request a price match. *T&C's apply!

Pay nothing for up to 60 days with Shift!
Get an additional 30 days FREE on top of our 30 days standard payment terms from interest and repayments.

 

 

Product Description

Fine, brushable cementitious coating that features unique penetrative technology

Hydroc Fairing Coat is a fine, brushable cementitious coating that features unique penetrative technology and has been developed specifically for providing waterproofing to old and new concrete structures from positive and negative water pressure.

Benefits:
- Developed for providing waterproofing to old and new concrete structures from positive and negative water pressure
- Contains migrating corrosion inhibitor which significantly increases the corrosion protection of steel reinforcement in concrete
- Reinstatement of trafficable concrete surfaces
- Crack repair systems
- 0-1.5mm build per coat

Application Instructions:

Surface Preparation
Remove any weak, spalling, unconsolidated concrete and any existing coating and thoroughly clean surface. If steel reinforcement is exposed remove any rusting on the steel surface. If patching is required, please patch with Hydroc Cempatch or High Build Mortar (Hydroc Fairing Coat is a coating only).
Concrete must have the open capillaries. If surface is covered with oily matter the concrete is to be lightly sandblasted, acid etched, or pressure washed. Then hose the concrete surface to fully impregnate with water and allow drying to a wet dull lustre and puddle free.

Application Method:

Priming
We recommend priming as a part of the installation process described below. Aardcure Catalyst (as a primer) is applied on the concrete substrate in order to passivate the steel reinforcement embedded beneath the concrete and completely harden the concrete surface, creating an appropriate adhesion platform; and as a result, the increased bond strength of Hydroc Fairing Coat coating.
Apply Aardcure Catalyst at the rate of one litre per 3-5 square metres on the dry touch concrete substrate to fully impregnate with Aardcure Catalyst (instead of the water impregnation in the process of surface preparation) and allow drying to a wet dull lustre and puddle free.

Mixing
Use a low sheer mechanical mixer to ensure proper mixing.
Normal water requirement is 3.3-3.7 L per 20 kg pail dependent on required viscosity.
Place 3 litres of water in a clean mixer bucket. While stirring gradually add Hydroc Render, and mix thoroughly for 2-3 minutes.
If necessary, add additional water, until a mix of the desired workability is obtained. Mix for a further minimum 1 minute. Use within 30 minutes.

Application
Apply by concrete brush to a wet, puddle free surface. With a concrete brush, use an aggressive circular motion to coat the concrete with the Hydroc Fairing Coat slurry mix.
To ensure complete coverage with no missed or thin spots, we recommend always applying two coats. The second coat can be applied as soon as the first has set hard. It is usually after about 4 hours depending on conditions.

Request A Free Quote

Please fill out the below form for a nonobligatory written quote on a Vulk Hydroc Fairing Coat 20Kg Bag.